42
W-800
Installation
Program the drive head
This section describes the normal programming of the drive head during installation.
For further adjustments, or for special adjustments, refer to the section ‘Special settings’.
Preparation
1.
Make sure that the garage door is securely engaged in the carriage.
2.
Make sure that the aerial is correctly positioned.
3.
Make sure that you have all hand transmitters for this garage door at hand.
4.
Open the cover of the drive head with a screwdriver.
5.
Connect the mains plug to the mains socket. The point display lights up.
Menu 1:
Program the start signal of the hand transmitter
1.
Briefl y press the programming button (PROG button) (D).
The display shows “1”.
2.
When the display fl ashes, press the hand transmitter button with which
you will later start the drive until the digital point (A1) on the display blinks
4 times.
3.
As soon as the light goes out, you can set the next hand transmitter (see
Step 1).
Note:
Up to 30 codes can be learned.
D
C
B
A1
Menu 2:
Programming the 4-minute light
1.
Briefl y press the programming button (PROG button) (D) twice.
The display shows “2”.
2.
Press the button on the hand-held transmitter to control the light until the
digital point (A1) fl ashes 4x.
3.
As soon as the light goes out, you can set the next hand transmitter (see
Step 1).
Note
: Programming the ventilation position and partial opening:
see menu 9.
Note
: Up to 30 codes can be learned.
(Example 15x start 15x light).
Delete all radio codes
1.
Pull the main plug
2.
Push and hold the oval PROG-Button (D).
3.
Connect the mains plug to the mains socket and keep the PROG button
(D) pressed until the digital point fl ashes quickly.
D
C
B
A1
