Tormach PSG 612, Operator'S Manual

Page: 14 / 36

POWERING UP THE MACHINE
1.
Connect the main power cord to an approved IEC wall
outlet.
2. Turn the main disconnect located on the side of the
cabinet to on.
3.
Rotate the red emergency (E-stop) knob located on the
electrical box.
4.
All of the LED lights on the control panel will blink
once, indicating power to the machine.
5.
If either of the LED lights for the speed or feed button
is active (red), the table is outside the defined range of
motion and the table is tripping a proximity switch.
6.
Manually adjust the table in the X- or Y- direction if
necessary. The table should move freely.
7.
When the table location is within the limits, the red
LED lights will turn off.
8.
Select the desired grinder operation mode by pushing
the Mode Select button until the LED light to that
operation turns green.
9.
Press/toggle the black start button to start and stop
table motion. The E-Stop button should be used in
emergency situations and to completely terminate
power to the machine.
USING THE MAGNETIC CHUCK
To install the Magnetic Chuck (Tormach Part Number
33210) for workholding:
1.
Locate the auxiliary clamps with bolts and nuts
(included in the tool box).
2.
Wipe the table surface clean, removing any debris or
material.
3.
Place the magnetic chuck on the grinding surface.
4.
Insert the bolts in the T-slots located on either side of
the magnetic chuck.
5. Lower the clamps down onto the bolts and then
slide the fixture into the grooves on each side of the
magnetic chuck.
6.
Slide the washer and nut down onto the top of the
bolts and tighten.
7.
Insert the wrench into the slot on the front face of the
magnetic chuck. Rotate the wrench to the direction
of “on” or “off” to activate or deactivate the magnetic
field.
UM10159_PSG612_OPERATORS_MAnUAl_0718A
12 13
UM10159_PSG612_OPERATORS_MAnUAl_0718A