Tormach PSG 612, Operator'S Manual

Page: 13 / 36

CONTROL MODES AND POWER
CONTROLS
Speed and Feed
The speed and feed knobs are used to control the motion
of the work table. Speed controls X-axis motion and Feed
controls how far the table moves in the Y-axis. Turn the
knobs in a clockwise direction to increase speed or feed.
Wheel On/Wheel Off
The Wheel On and Wheel Off buttons turn the grinding
wheel on and off, respectively. Wheel Off will not stop the
X- or Y-axis.
1.
Mode Select Button
Push this button to switch between grinding modes. Each mode
has a green LED below the mode symbol to indicate the mode is
active. The machine will not change feed modes while in motion.
2.
Feed at Both Ends
The grinder feeds in the Y-axis at each end of the X-axis stroke.
3.
Feed at Left End Only
The grinder feeds in the Y-axis at the left end of each X-axis stroke.
4.
Continuous Feed
The Y-axis is in continuous feed at set feed.
5.
No Feed
Use this feed for plunge grinding. No Y-axis motion.
Start/Stop
The Start/Stop button starts and stops table motion.
E-Stop
The E-Stop button supplies power to the machine. Rotate
to power up
Main Power Disconnect
The Power Mains switch (located on the side of the control
panel) completely disconnects the machine from an
electrical power source.
Speed
Feed
GRINDER OPERATION
UM10159_PSG612_OPERATORS_MAnUAl_0718A
10 11
UM10159_PSG612_OPERATORS_MAnUAl_0718A