Tormach, Inc.
P: 608.849.8381 / F: 209.885.4534
tormach.com
TECHNICAL DOCUMENT
Page 5
©Tormach® 2017. All rights reserved.
Specifications subject to change without notice.
TD10246_Tool_Post_Install_0317A
9.
Swing Tool Post Handle up to unlocked position (see
Figure 9
).
NOTE:
Tool Post lever must be in unlocked position to attach holder.
10.
Slide Tool Holder onto Tool Post dove tail (see
Figure 9
). Swing Tool Post Handle down to locked position.
11.
Attach magnetic dial test indicator to spindle. Position indicator tip against tool face. Power up lathe and
move carriage back and forth on X-axis against indicator tip (see
Figure 10
).
12.
To correct Tool Post misalignment, tap with dead-blow hammer to adjust, as necessary (see
Figure 10
).
Repeat Steps 11 and 12 until suitable alignment is achieved.
13. Tighten Tool Post nut securely with adjustable
wrench (see
Figure 11
).
14.
Recheck tool with dial indicator to ensure
position did not change following tightening of
nut.
Figure 9
Locked
Unlocked
Figure 10
Figure 11
