Tormach 1300PL, Operator'S Manual

Page: 39 / 100

4: INSTALLATION
4. If applicable, verify the optional Jog Shuttle:
l
Press any axis button on the Jog Shuttle — X , Y , Z , or
A — to select an axis.
Figure 4-10: Functions on the optional Jog Shuttle.
From the PathPilot interface, on the Main tab, the
corresponding green Axis light comes on.
Figure 4-11: Axis lights.
l
Turn the Jog Shuttle Ring in any direction to move the
selected axis, then turn it in the opposite direction to
reverse the direction.
4.12.5 Testing Plasma Source Control
1. Using the "Connectors Reference" (page 45) verify that
the Hyperthem control cable is connected to the correct
spot on the rear of your electrical cabinet.
2. Jog the torch to a location several inches above the
water table so that you can safely test the arc.
3. Activate the plasma source and create a pilot arc by
pressing the TEST TORCH button in PathPilot.
4. Verify that your plasma source activates and creates a
pilot arc (you may have to press the button twice to
bypass the "warning puff" function on some plasma
sources).
5. While the pilot arc is active, watch the "Torch Voltage"
readout at the bottom of your control screen.
You should see an open-circuit voltage of above 100V. If
you do not see a voltage reading, follow the "Voltage
Feedback" (page 68) section of the Troubleshooting
guide.
©Tormach® 2020
Specifications subject to change without notice. Page 39 UM10720: 1300PL Operator's Manual (Version 0820B)
For the most recent version, see tormach.com/support