6
Installation Notes:
Step 1:
Begin by placing the transmission in "Park" and/or chocking the tires.
Remove the spare tire. Remove the Vibration Damper from the Driver
’
s
Side of the factory hitch. Then, carefully disconnect the wiring harness
from the bumper. Remove the wire harness from the side plates.
Step 2:
Take the bumper off by removing the two bumper support bolts on each
side of the receiver as shown in Figure 2.1. Remove the two nuts on either
side of bumper as shown in Figure 2.2. Gently pull the bumper away from
the vehicle, checking to make sure the wiring harness has been completely
disconnected. It may be helpful to a second person to support the bumper
during removal. Set the bumper aside for reassembly.
Figure 2.1
Bumper support
bolts
