Toptica FemtoFiber pro IR, Manual, Page: 58 / 108

FemtoFiber
®
pro Laser System
Page 54
Status: 6.9.18
5.5.3 Laser Control Tab
Figure 46 Laser Control tab (example)
ON/OFF Clicking switches the laser emission ON/OFF.
set level Changing the set level reduces the laser power (1 corresponds
to 100 %). When the laser power is reduced, the laser is not
operating under standard specification and the white Laser
Radiation Emission Warning LED on the FemtoFiber
®
pro Laser
Head is blinking.
This function is only for alignment purposes.
FFpro.arm0.level Displays the actual set level for the main laser.
Si prism target position Changing the target position of the motorized prism compressor
allows to optimize the pulse length (IR, IRS-II, NIR) or spectral dis-
tribution (SCIR, UCP, TVIS, TNIR).
FFpro.arm0.axSi.pos Displays the actual target position of the Si prism.
auto optimize Clicking switches the auto optimize feature ON/OFF. When
switched ON, auto optimize constantly adjusts the average
power to maximum.
NOTE ! For constant pulse timing, auto optimize should be
switched OFF !
optimize now Starts the auto optimize procedure.
scan now Starts a search for maximum average power over the whole
prism set range and adjusts the average power to maximum.
Indicator laser triangle A yellow colored laser warning symbol is shown at the right side
of the window when the laser emits light.
NOTE ! The following operator controls are only available if the optimization feature is imple-
mented (not available for all system variants).