Toppro TPR-5000, User Manual

Page: 79 / 82

A
71
No picture through RF loop out to my Television
To output an RF signal in standby mode the recorder must be
set to Active. This can be adjusted in the
Settings
>
Miscella-
neous
>
Standby Mode
, putting
Tuner Loop Through
to
On
.
My Toppro recorder doesn’t go to standby after instant recording (non timer
recording)
When an instant recording has been activated the recorder
will need to stay on until the recording finishes. To place the
recorder into Standby after the recording has finished press the
Power button on the remote during a recording and the follow-
ing message is displayed “RECORDER NOT FINISHED, DO
YOU WANT TO POWER OFF?” move green tab to YES and
leave recorder ON, do not execute the function. The television
may be turned off and the recorder will go into standby (sleep
mode) when the recording has finished.
Cannot view guide content
Perform a factory reset and service search to allow the unit to
restart the guide. Be sure to save your settings in the Installa-
tion section before applying a factory reset.