MAINSHEET
1. Thread the mainsheet through the mainsheet block
assembly in reverse as pictured.
2. Then feed the mainsheet rope up to the boom,
through the boom block and down again.
4. Then take the rope up to the boom and through the
block becket as shown and tie off using a figure of eight
knot as shown.
5. Then pull the tail of the mainsheet rope through the
ratchet block.
RUDDER ASSEMBLY
1. Attach rudder blade assembly to transom plate.
Ensure that rudder retaining clip snaps back into original
position to hold rudder assembly in place.
DAGGERBOARD
1. Attach thick elastic to top of centreboard
and place board into centreboard slot.
Attach the elastic around foot of mast with
the plastic clip.
3. Then feed the rope through the top of the mainsheet
block as shown.
6
Then tie a stop knot using a figure of eight knot.
1
