TMW
SERIES
TMW
SERIES
CONTROL ELEMENTS
5.Antenna
It is the flexible antenna. To get effective transmission, never cover the antenna with hand, clothes, etc.
During the operation, and always position the transmitter nearby the receiver.
6. GT Level Switch
It is used to adjust the input signal level of electrical guitar. When an electrical guitar is being used it is
ineffective to adjust MT level switch.
9. Adjusting Bar
It is used to adjust BAND SELECTOR, MT SWITCH and GT SWITCH.
7. MT Level Switch
It is used to adjust the input signal level of microphone. When an microphone is being used it is ineffective
to adjust GT level switch.
8. Band Selector
With the adjusting bar, the band selector can be used to switch to an expected frequency before switching
the frequencies, turn off the transmitter first and then turn on it.
10. Power LED
When the unit is turned on, this LED flashes once. When the unit is turned off this LED lights off slowly.
When the batteries are short of power, this LED flashes. When the batteries can not be used, this LED
lights up.
OPERATION
5.1 PLL UHF DIVERSITY RECEIVER
SQUELCH CONTROL
The job of a squelch circuit is to reduce audible noise. It eliminates noise during pauses in the audio
signal by muting the receiver every time and the audio level drops below a def ined th resho ld. The s quelc h
control on the receiver sets this threshold. Use the squelch control with care! If the squelch threshold
is too high, the squelch will not only cut out noise but mute quiet audio signals as well because the
squelch
responds to the detected voltage and cannot distinguish between wanted signal and noise.
Besides that, a too high squelch threshold also decreases the usable range. The squelch range is
95.0 dB~65.0 dB. Use an adjusting bar to adjust the squelch selector for a right squelch threshold.
MANUALLY SELECTING FREQUENCY
Press this flip switch slightly to switch channel for desired frequency.
OUTPUT VOLUME CONTROL
There is one master volume control "AF LEVEL" on the front panel. It is used to control the output volume.
Turn the knob clockwise and the output volume increases. Turn the knob counterclockwise and the output
volume decreases.
(8)
(9)
(3)(6) (7)
(5)
(4)
(2) (1) (10)
Pin1
Pin2
Pin4
Pin3
