第
7
页
/
共
17
页
⑬ Error code indicator
①
Determine if you need to select the corresponding mounting clamp and rubber clip ring according
to the diameter of the handle bar
（
Applicable handle bar specifications
：Φ22.2、Φ25.4、Φ31.8）
.
Open the display lock clamp and insert the rubber clip into the correct position of the lock clamp.
②
Set the rubber ring in the bracket then assembleon the middle of the handle bar, adjust the angle of
the display,make it easier to see the display screen when riding. After fixing the angle, tighten the
screws. Tightening torque is 1N.m.
③
Open the lock ring of the switch and set it in the prorate position on the left side of the handlebar.
Adjust the angle of the switch, so that rider can see the switch and operate easily. (Applicable handle
bar dimensionis Φ22.2)
④
Fix and tighten the handlebar fixing screw with M3Hex wrench, locking torque is 0.8Nm.
⑤
Connect the display connector to the controller connector according to the label.
Note:
Damage caused by excessive torque is not covered by the warranty
.
