３
accidents.
4.
DO NOT USE IN DANGEROUS ENVIRONMENTS.
Do not use power tools near
gasoline or other flammable liquids, in damp or wet locations, or expose them to rain.
Keep the work area well lighted.
5.
KEEP CHILDREN AWAY FROM POWER TOOLS.
All visitors should be kept at a
safe distance from the work area.
6.
MAKE THE WORKSHOP CHILDREN-PROOF
with padlocks and master switches or
by removing starter keys.
7.
DO NOT FORCE THE TOOL.
It will do the job better and safer at the rate for which it
was designed.
8.
USE THE RIGHT TOOL.
Do not force the tool or attachment to do a job for which it
was not designed.
9.
USE THE PROPER EXTENSION CORD.
Make sure your extension cord is in good
condition. When using an extension cord, be sure to use one heavy enough to carry
the current your product will draw. An undersized cord will cause a drop in line
voltage resulting in loss of power and overheating.
10.
WEAR PROPER APPAREL.
Do not wear loose
clothing
, glove, neckties, rings
bracelets, or other jewelry that could get in moving parts. Non-slip footwear is
recommended. Wear protective covering over long hair.
11.
ALWAYS WEAR SAFETY GLASSES.
Everyday eyeglasses have only
impact-resistant lenses; they are NOT safety glasses.
12.
SECURE THE WORK.
Use clamps or a vise to hold work when practical. It is safer
than using your hands to operate the tool.
13.
DO NOT OVERREACH.
Keep proper footing and balance at all times.
14.
MAINTAIN THE TOOL WITH CARE.
Keep
tools
clean for the best and safest
performance.
15.
DISCONNECT POWER TOOLS BEFORE SERVICING
or before changing
accessories such as the
sand paper
.
16.
REDUCE THE RISK OF UNINTENTIONAL STARTING.
Make sure the switch is in
the OFF position before plugging in the tool.
17.
USE ONLY THE MANUFACTURER’S RECOMMENDED ACCESSORIES.
Consult
this owner’s Manual for recommended accessories. Using improper accessories
may increase the risk of injury.
18.
NEVER STAND ON THE TOOL.
Serious injury could occur if the tool is tipped or if
the blade is unintentionally contacted.
19.
CHECK DAMAGED PARTS.
Before further use of the tool, a guard or other part that
is damaged should be carefully checked to determine if it will operate properly and
perform its intended function. Check for alignment of moving parts, binding of moving
parts, mounting, and any other conditions that may affect its operation. A guard or
other part that is damaged should be properly repaired or replaced.
20.
DIRECTION OF FEED.
Feed work into a blade or cutter against the direction of
rotation of the blade or cutter only.
21.
NEVER LEAVE THE TOOL RUNNING UNATTENDED.
Turn off the power. Do not
leave the tool until it comes to a complete stop and is disconnected from power
Summary of Contents for MM3156
Page 27: ...DIAGRAM 1...
Page 29: ...DIAGRAM 2...
