TOPMAQ MM3156, Owner'S Operating Manual

Page: 18 / 32

１７
Figure 12
NOTE: If the unit is bolted to a stand or bench, loosen the mounting
bolts at the motor end.
2. Using the Height Adjustment Handle Assembly, lower the drum until the
distances at A and B are equal. Tighten the alignment bolts and the mounting
bolts.
3. Sand a piece of wood and check for uniform thickness. Repeat the above
procedure if necessary.
CONVEYOR FEED BELT TRACKING ADJUSTMENT
Occasional adjustment of the conveyor feed belt tracking may be required due
to belt stretching. Ideally, the conveyor feed belt should track in the center
area of the conveyor feed belt table.
1. Conveyor feed belt tracking adjustment screws are located on both the
inboard and outboard sides on the rear of the Wide Drum Sander . (See
Figures 12 )
2. To tighten the tracking tension, the tracking screw is rotated clockwise
while holding its nut in place with a 11mm open-end wrench (not supplied).
To loosen the tracking tension, the tracking screw is rotated
counterclockwise while the nut is held with the wrench. (See Figure 15.)
Inboard
Conveyor
Table
Alignment
Bolts.
Front
Inboard
Conveyor
Table
Alignment
Bolts.
Rear