TOPMAQ LST3700, Instructions & Assembly

Page: 8 / 21

- 8 -
STEP 3: Attach the Beam Assembly
1. Attach the beam assembly (#17) to the hydraulic reservoir and secure using the hitch pin (#18)
and R Pin (#21).
STEP 4: Attach Engine and Hydraulic Hose
1. Place four polyurethane blocks (#55) and large flat washer Ø10 (#58) in the mounting plate.
2. Position the engine (#33) over the blocks and washers, secure it to the mounting plate, put the
hex bolt M10x75 (#46) through the bottom of the plate (bolt should go through blocks, flat
washer and engine base). Place a lock washer Ø10 (#90), flat washer Ø10 (#84) and tighten
with nylon lock nut M10 (#83)
3. Attach the clear oil pipe (#53) to the bottom of the gear pump and secure with clamp (#51).
4. Put O ring Ø14x2.5
(#19) on the gear pump outlet connector (#23), attach the hydraulic hose
(#16) to the joint of gear pump (#23).
5. Put O ring Ø17x2.5 (#71) on the connector of hydraulic reservoir, attach the hydraulic hose (#7)
to the connector.