TOPMAQ LST3700, Instructions & Assembly

Page: 16 / 21

- 16 -
Problem
Cylinder rod will not move SOLUTION: A,D
Slow cylinder rod speed when extending
or retracting
SOLUTION: A,B,D,I
Wood will not split or splits extremely
slowly
SOLUTION: A,B,D,G,I
Valve will not stay in detent or will not kick
out of detent position
SOLUTION:H
Engine bogs down during splitting SOLUTION: This is normal
Engine stalls under low load condition SOLUTION: L
Engine will not start SOLUTION: C,E,F
Engine is difficult to turn over and will not
start when cold
SOLUTION:J
Engine runs but cylinder does not move SOLUTION: D,K
Cause Solution
A -Insufficient oil to pump Check oil level in reservoir
B -Air in oil Check oil level in reservoir
C -Low engine oil Check and add engine oil
D -Blocked hydraulic lines Check for restriction
E -“ON”/“OFF” Move to “ON” position
F -Fuel shut off in “OFF” position Move to “ON” position
G -Damaged control valve Return control valve for authorized repair
H -Detent setting incorrect Remove plastic cap on valve and adjust
detent kick out pressure
I -Internally damaged cylinder Return cylinder for authorized repair
J -Cold ambient temperature Cold weather (below 32°) can result in
difficult engine starting. Change to ATF.
K -Broken pump / Engine coupler Check and replace coupler
L -Defective pump or engine Contact service center
Troubleshooting