TOPMAQ LST3700, Instructions & Assembly

Page: 7 / 21

- 7 -
STEP 1: Attach Wheel
1. Attach the wheel (#35) to the hydraulic reservoir axle (#44) using a bearing (#82), flat washer
Ø20 (#54) and tighten the wheel with the hex slotted nut M20 (#37). Lock the hex slotted nut
M20 (#37) in place using the cotter pin Ø4x36 (#73). Install the axle cap (#41) on the end using
rubber hammer.
Note: flat washer Ø20 (#54), hex slotted nut M20 (#37) and cotter pin Ø4x36 (#73) are already
assembled in the log splitter.
2. Attach engine mounting plate (#95) to the hydraulic reservoir using hex lock nut M10 (#83), flat
washer Ø10 (#84) and hex bolt M10x30 (#85).
STEP 2: Attach Tow Bar to the Hydraulic Reservoir
1. Attach the tow bar (#62) to the hydraulic reservoir and secure using two hex bolt M12x100
(#24), flat washer Ø12 (#65) and nylon lock nut M12 (#13).
Assembly Instructions
WARNING: After tightening the slotted nut,
loosen nut 1/4 of a turn so the tire will rotate
freely. Failure to loosen the nut may cause
excessive bearing and tire wear.