Topfloor TF100R-TRS, Operator'S Manual, Page: 29 / 40

TF100-TRS 27

Take the key out of the key-operated switch.

Pull up the lowering lever for the side brushes.

Arrest the lowering lever.

Pull off the spring plug from the axle of the lateral brushes.
1 Borehole 2 Borehole
3 Flange of the lateral brush-
es
4 Spring plug

Pull the side brush down and off.

Replace the side brush.
5.11.2 Mounting the Side Brush

Fasten the flange plate to the side brush.

Push the lateral brush on the axle of the lateral brushes.

Push the spring plug through the borholes of the lateral brush flange
plate and through the borehole of the axle of the lateral brushes (un-
til ground contact).
5.12 Overload safety cutouts
When seen in direction of motion the overload safety cutouts are located
on the left, below the rear cover, and protect the electric motors against
overload.
If an overload safety cutout responds, the respective electric motor will
not run:

Switch off the ride-on-suction-sweeper.

Wait for some minutes.

When seen in direction of motion, lift up the left side of the back of
the hood.

Secure the back of the hood just lifted with the hood locking device.