12
3.3 Attach Rail to Header Bracket
3.4 Position the Opener
Position opener on garage floor below the
header bracket. Use packing material to
protect the cover. Raise rail until holes in the
header sleeve and holes in the header
bracket align. Join with clevis pin (1). Insert
“R” pin (2) to secure.
NOTE:
To enable the rail to clear sectional
door springs, it may be necessary to lift opener
onto a temporary support. The opener must
either be secured to a support or held firmly in
place by another person.
Raise the opener onto a stepladder. Open
garage door. Place a 25mm (1") board (1)
laid flat on the top section of door near the
centerline as shown. Rest the rail on the
board.
If the raised door hits the trolley, pull down on
the trolley release arm to disconnect the
inner and outer trolley sections. The trolley
can remain disconnected until connecting
door arm to trolley is completed.
NOTE:
A 25mm (1") board (1) is convenient for
setting an ideal door-to-rail distance (unless
headroom is not sufficient).
Summary of Contents for MultiRuta CASAR 800
