EN
20
21
If more than one DTC is found, press and hold the “ ” or “ ” until all
the codes have been shown up.
If no codes are detected, a “
No codes are stored in the module!
”
message displays on the screen.
If retrieved DTCs contain any manufacturer specific or enhanced
codes, the display indicates “
Manufacturer control
”.
NOTE: The control module number, sequence of the DTCs, total number
of codes detected and type of codes (Generic or Manufacturer specific,
Stored or Pending codes) will be observed on the upper right hand corner
of the display.
NOTE: The control module number, sequence of the DTCs, total number
of codes detected and type of codes (Generic or Manufacturer specific,
Stored or Pending codes) will be observed on the upper right hand
corner of the display.
4)
Press and hold the “
EXIT
” to return.
5)
▼
▲
3.Erasing Codes
If you decide to erase the DTCs, press and hold the “ ” or “ ” to
select “
Erase Codes
” and press “
ENTER
” to confirm.
1)
▼
▲
