EN
16
17
Operation Introduction
Connect ArtiLink200 with your vehicle.
NOTE: Don’t connect or disconnect any test equipment with ignition on or
engine running.
Turn the ignition off.
Locate the vehicle’s 16-pin Data Link Connector (DLC).
Plug into the OBDII cable to the vehicle’s DLC.
Turn the ignition on. Engine can be off or running.
Press “
ENTER
” button to enter “
Diagnostic Menu
”. A sequence of
messages displaying the OBDII protocols will be observed on the
display until the vehicle protocol is detected.
1)
2)
3)
4)
5)
1.Setup
The code reader allows you to make the following adjustments and
settings:
Language: Selects desired language.
Unit of measure: Sets the unit of measure to English or Metric.
Contrast adjustment: Adjusts the contrast of the LCD display.
1)
2)
3)
