Surveying with the Receiver
P/N 7010-0713
3-11
9. Select the
Base
tab, set the following parameters (Figure 3-8),
and click
Apply
:
•
GPS/GLO at one time
– enable
• Antenna position – enter Lat, Lon, and Alt values. Do one of
the following:
– If known, type in the values.
– Enable
Averaged
and enter the
Averaged Span
in seconds,
then click
Apply
. Click
Tools
Reset receiver
and wait
until the specified interval (span) completes. Examine the
Base coordinates on the Base tab, they should correspond
to the coordinates obtained from the average. Click
Refresh
if the coordinates are zeros.
– Click
Get from receiver
.
NOTICE
NOTICE
The reference geodetic coordinates specified on this tab
relate to the antenna L1 phase center.
Figure 3-8. Base Configuration