Getting Acquainted
P/N 7010-0713
1-13
Table 1-2 describes the operating times for the HiPer XT receiver,
with the internal batteries fully charged and dependent on the mode of
the modem.
The Li-Ion batteries used in the HiPer XT should run at no less than
98% capacity after 500 charging cycles. These batteries do not need
to be drained before recharging.
A battery charger (AC adapter) is included with the standard package.
See Appendix A for technical specifications on the battery.
External Components
The HiPer XT casing includes panels for radio antenna attachment, a
user interface, a power port, and ports for configuration.
Bottom Panel
The bottom panel of the HiPer XT receiver has the receiver serial
number, receiver part number, receiver type (Base or Rover), and
antenna reference point (ARP).
Radome
Figure 1-4 on page 1-14 shows the radome components:
• Internal antenna – Location of GPS/GLONASS internal antenna.
• Modem antenna connector – Modem antenna connector used for
internal modem RF connection. This is a BNC female connector
for UHF modems.
Table 1-2. Operating Times
Modem Mode
Base
Rover
TX mode ON (2W)
11 hours
--
TX mode ON (1W)
??
--
RX mode ON
--
14 hours
OFF
16 hours
16 hours