Configuration
HiPer XT Operator’s Manual
2-34
14. Click the
Serial Interface
tab and select a baud rate for the
modem’s serial port. The same rate must be used for both the
receiver and the modem.
15. Click
Apply
, then click on
File
and select
Disconnect
. If you
want to close the program, click
File
Exit
.
16. Launch PC-CDU and set up the receiver to run as an RTK Base
Station. For how to set up an RTK Base using PC-CDU, refere to
your receiver’s documentation or
PC-CDU User’s Manual
.
Configuring a Rover Station’s UHF
Radio Modem
NOTICE
NOTICE
To comply with RF exposure requirements, maintain at
least 25cm between the user and the TPS UHF radio
modem.
Repeat steps 1-4 from page 2-27.
When finished configuring the radio modem, always disconnect from
Modem-TPS before exiting to prevent conflicts with serial port
management.
There are two scenarios for configuring the radio-modem:
• With a dedicated channel.
• With the FCS mode.
Set Radio Link Parameters for a Dedicated
Channel
1. From the
Protocol
control, select between TPS and PDL.
• TPS – Select this protocol if all of the radio-modems at your
jobsite are manufactured by Topcon Positioning Systems.
• PDL – Select this protocol if you use PDL radio-modem(s)
together with TPS radio-modem(s) at the jobsite.