Topcon HiPer II, Operator'S Manual, Page: 70 / 140

HiPer II Configuration
HiPer II Operator’s Manual
3-14
Figure 3-15. Ports Configuration
9. Click
OK
to save the settings and close the dialog box. Once the
receiver is configured, the configuration remains until it is
changed using TRU, TopSURV, or the NVRAM is cleared. For
more details on the settings available for configuring receivers,
refer to the
TRU Reference Manual
.
10. For RTK Rover receivers, click the
Status
icon (Figure 3-19 on
page 3-21) to ensure the receiver obtains differential corrections.
Usually, the receiver will start to output the coordinates of the
antenna’s phase center along with the solution type within 10–30
seconds. However, spread spectrum radios and GSM phones may
take as long as 60 seconds to synchronize.
The Data Link tab reflects the status of the received differential
messages and contains the following information:
• Data link quality in percentage
• Time (in seconds) elapsed since the last received message
• Total number of received correct messages (dependent on the
message type received)
NOTICE
For post-processed surveys, keep the default values
for these parameters.
HiPerII_OM.book Page 14 Wednesday, December 15, 2010 9:07 AM