- 6 -
4.2
AC Plug
The WP-2 comes with a power input cord terminated with a Seetronic Powerkon connector on one end and
an EU plug on the other end (EU market). If the power input cord that came with your product has no plug,
or if you need the change the plug, use the table below to wire the new plug:
Connection
Wire (U.S.)
Wire (Europe)
AC Live
Black
Brown
AC Neutral
White
Blue
AC Ground
Green
Green/Yellow
4.3
Resetting the Breaker
This product is equipped with a resettable breaker. If the breaker trips, all sections of this product will lose
power.
•
Remove the power cord from mains power.
•
Allow unit to cool for 15 minutes.
•
After 15 minutes, you may attempt to reset the breaker by pressing the button with your finger.
•
Plug the product’s power cord into the power outlet and continue using as recommended.
4.4
DMX Linking
You can link the WP-2 to a DMX controller using a 3- or 5-pin DMX connection. If using other DMX-
compatible products with this product, you can control each individually with a single DMX controller.
Instructions for connecting and configuring this product for DMX operation are in the User Manual.
4.5
Mounting
Before mounting the product, read and follow the safety recommendations indicated in the Safety Notes.
4.5.1
Orientation
For safety reasons, we do not recommend mounting the product in any capacity. Operate the product while
it is on the ground only, and make sure there is adequate room for ventilation, configuration, and
maintenance.
Do not mix bubble fluid and fog fluid.
4.5.2
Rigging
DJPOWER recommends using the following general guidelines when mounting this product.
