- 9 -
Wireless Receiver
Wireless transmitter
When use W-2 wireless remote controller, the working status is based on bubble output, haze
output, wind output and LED color set by the LCD control board.
•
Plug the wireless receiver into the bubble fogger 5-pin port labeled “Wireless Controller”. The red LED
indicator will be on when the transmitter is successfully connected. There is no any reaction in the green
LED indicator.
•
There are 4 buttons on the wireless remote transmitter which act as triggers. Each button can be
assigned to a different Bubble fogger WP-2. You may only choose 1 dipswitch on each receiver. See the
below configuration options for setting the receivers to operate with the transmitter remote.
•
Press the button, and the Bubble fogger WP-2 will run momentarily for as long as you hold down the
button• Release the button, the unit stops running.
5.4
DMX Mode & Operation DMX
The machine WP-2 works with a DMX controller.
•
Connect the product to a suitable power outlet
•
Turn the product on.
•
Connect a DMX cable from the DMX output of the DMX controller to the DMX input socket on the
product.
Staring Address
When selecting a starting DMX address, always consider the number of DMX channels. If you choose a
starting address that is too high, you could restrict the access to some of the product’s channels.
DJPOWER WP-2 DMX set the stating address in the 001 - 512 DMX range and uses 12 DMX
channels, which defines the highest configurable address to 501 to have all channels
controllable.
Connect a DMX cable from the DMX output of the DMX controller to the DMX input socket on
the product, or press repeatedly “MENU” button until the LCD shows “DMX Address”, Press UP
or DOWN to set desire DMX starting address.
Mode
Dipswitches
CH1
1 = On, 2-4 = Off
CH1, CH2
1, 2 = On, 3,4 = Off
CH1, CH2, CH3
1, 2, 3 = On, 4 = Off
CH1, CH2, CH3,CH4
1, 2, 3, 4 = On
…
…
Dipswitches
LED indicator light
