10
www.topazsystems.com
GemView 10 & 10 Touch Tablet Display User Manual
Connect Pen to Tablet Display
If your pen is not already connected to the tablet display, follow these instructions:
1. Loop one end of the pen tether through the eye at the end of the pen.
2. Loop the other end of the pen tether through the tether hole on either side of the device.
3. Note that the pen can lie flat in the pen holder slot, or it can stand vertically in the hole at
the top of the pen holder slot.
Install DisplayLink Driver
Note: If you are installing the driver for a Citrix VDA machine, you should not perform this
step; continue to the section “Install GemView Tablet Display Driver”.
Download and run the DisplayLink installer from the Topaz website:
www.topazsystems.com/software/download/displaylink.exe
. This software provides
extended display functionality for the tablet display.
For silent installation, use the command -silent. For more information, view:
Configure Tablet Display for Installation
Use the Display program in the control panel to configure the tablet display for your installation
(see screenshot below). You may specify the following characteristics:
1. Resolution:
Use the recommended resolution
2.
Orientation:
Landscape or portrait
3.
Multiple displays
: Extend these displays
4.
Alignment
: Make sure that the bottoms of the monitors are aligned as shown below, and
that the tablet display (Display 2) is on the side of the main display you want to use when
moving windows from the main display (Display 1).
