6
MINI MILLING MACHINE
EN
Translation of the original manual
START UP
The compressed air network must be perfectly purged and adapted to the consumption of the tool. A pressure-reducer and lubricator filter (except for
tools without lubrication) of appropriate size must be installed at a maximum distance of 10 metres from the tool. Its regulation pressure must be set
at 6.2 bar and the special oil flow rate for tools to be lubricated must be about 1 drop of oil every 30 seconds for an air flow rate of 100 litres/mm. Be
careful, the air consumption of your tool must be higher than the minimum priming rate of your lubricator. A shut-off valve must be placed upstream.
The connection between this filter-regulator-lubricator unit and the tool is made with a special «compressed air» rubber or PVC «compressed air»
hose with a maximum length of 10 metres and an internal diameter of at least 8 mm for tools with a 1/4» supply connection and 12 mm for 3/8»
connections. It must be equipped with an automatic or semi-automatic closing connection close to the tool, for easy disconnection.
APPLICATION
• Only use accessories in perfect condition that correspond to the characteristics of the tool.
• Avoid running the tool empty. If this is the case, after a long period of use, make sure that no accessories are attached to the tool. It is essential
to disconnect the tool for the installation of accessories. Check that they are perfectly fitted before connecting the tool.
• Regularly inspect the condition of the supply piping. In the event of damage or leaks, proceed to immediate repair. A broken pipe can cause
serious injury. Periodically check lubricator levels, filter and pipe purging.
MAINTENANCE
• At the beginning of the day or before a prolonged period of no use, pour a few drops of special oil directly into the hole. Do not use flammable
liquids such as gasoline and diesel.
• Regularly check the condition of the regulating filter and the oil level in the lubricator of the air system.
• Ensure that the supply connections, piping and accessories are in perfect condition. Regularly drain the compressor pipes and tank. Don’t forget
your probation deadline.
• Only original parts available from the supplier may be used for tool maintenance.
• The company cannot be held responsible for changes in tools and non-compliance with general safety rules relating to the use of compressed air.
TECHNICAL FEATURES
Connection
socket diameter
(mm)
Rotational
speed (t/min)
Length
(cm)
Weight
(gr)
Noise level
dB(A)
Noise pressure
dB(A)
Consumption
(L/min)
Air pressure
(bars)
Power supply
connection
Ø3 mm
Ø6 mm
25 000
121
300
97
86
113
6.2
1/4’’
CUTTING HEAD CHANGE
1) The mini milling machine is supplied with
two caps (Figure 1) and two tightening tools Ø
6 mm and Ø 3 mm (Figure 2).
To use of the round cutting head (ref. 063235),
using a Ø 3 mm recess.
Figure 1
Figure 2