1
carbon fiber tube(14x423mm)A
1
carbon fiber tube(14x213mm)B
1mm
Tailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
Elevator
Apply instant type AB glue to elevator and hinges.
Keep some space about 1mm width between
elevator and tailing edge.
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Epoxy the elevator to the stabilizer.
Make sure hinges are
mounted in the same line.
12
Horn
8
pivot & round hinge(5x68mm)
8
pivot & round hinge(5x68mm)
Install the control horn and connect the linkage.
Trim a slot in the stabilizer base on the mark, put the servo of elevator into
the stabilizer through the hole in the wing root,install the servo to appro-
priate possition with screws and epoxy the horn to the slot in the elevator.
Ball joint
Ball joint
Lock Nut (2mm )
Lock Nut (2mm )
Washer(2x5mm)
Washer(2x5mm)
4
Clevis
4
4
Screw (2x10mm)
2
4
Washer(2x5mm)
Screw (2x10mm)
Screw (2x10mm)
Lock Nut (2mm )
Push rod(2mm)
Push rod(2mm)
Masking tape
Screw (2.6x12mm)
4
4
Washer(3x8mm)
9
Clevis
13
13
Screw (2x10mm)
2
13
Washer(2x5mm)
Lock Nut (2mm )
Push rod(2mm)
4
Copper joiner
4
Steel wire (0.5x3000mm)
4
Aluminum tube
16
1
Rod (2x200mm)
TP Screw (2.3x12mm)
4
Pin hinge(36x20x1mm)
2
Horn
2
Fibre glass tube(3x300mm)
Horn
4
16
TP Screw (2x10mm)
22
24
23
25
5
26
Accessory list for the coming installation steps.
