3
Assembly Steps
Step 1:
a: Use Philips Screw Driver to disassemble #07and #12 parts from 01(see figure below), and collect #12
(screw), take out of #07(motor cover) carefully from left and right side.
Step 2:
Set pillar (#05) into main frame (#01), use Hex Bolt and Flat Washer (as showed in figure) to fix #05, #13, #08
into Main Frame. (Do not fix them tight).Connect wire B of #01 and wire B of #05.
Notice: When setting main frame, it needs 2 persons to operate, avoiding connector caught. When
connecting, please note the direction of BNC and do not pull the wire hard.
