Customer Helpline
1300 889 028
17
Operating Instructions
could grab the work-piece, causing it to slip and twist.
12)
BEFORE
turning on the saw, perform a dry run of the cutting operation just to
make sure that no problems will occur when the cut is made.
13) Check position of the Trenching depth adjustment screw(32) and the Trenching
stop(33), making sure that they are adjusted properly to a desired height, so after
operating the blade cuts to a desired depth and would not harm to the base or table.
14) Hold the operating handle (1) firmly, when squeezing the switch trigger (19). Allow
several seconds for the blade to reach maximum speed.
15) Operating the release latch (2) and then, slowly lower the blade into and through
the work-piece.
16) Release the switch trigger (19) and allow the saw blade to stop rotating
BEFORE
raising the blade out of the work-piece. Wait until the electric brake stops the
blade from turning
BEFORE
removing the work-piece from the mitre table.
3. BEVEL CUTTING (See Fig. G)
A bevel cut is a cut made across the grain of the work-piece with the blade at an angle
to the work-piece.
A straight bevel cut is made with the mitre table set in the 0
o
position and the blade set at
an angle between 0
o
and 45
o
. Hold the operating handle and then loosen the bevel lock
knob (25), rotate the head to adjust the blade to a desired angle, Tighten the bevel lock.
Operation
E
F
G
H
