Customer Helpline
1300 889 028
13
Operating Instructions
3. WORK CLAMP (See Fig. C)
1) The work clamp (28) can be fitted on either side of the saw and is fully adjustable to suit
the size of the workpiece.
2) Do not operate the saw without clamping the workpiece.
3) Make sure that the work clamp securing screws are tightened.
4. MOUNTING HOLES
Your compound mitre saw should be permanently mounted to a firm, stable-supporting
surface, such as a workbench. Four bolt holes (35) have been provided in the saw base
for this purpose. Each of these four mounting holes should be securely bolted using
M8
machine bolts, lock washers and hex nuts (not included). Bolts should be long enough to fit
through the saw base, lock washers, hex nuts and the thickness of the workbench.
Tighten all four bolts securely. Carefully check the workbench after mounting the saw to
make sure that no movement can occur during use. If any tipping, sliding or walking is
noted, secure the workbench to the floor before operating.
WARNING!
Always make sure your compound mitre saw is securely mounted to a
workbench or an approved work-stand. Failure to do so could result in an accident,
resulting in possible serious personal injury.
When the saw is boxed, in storage, or being transported, make sure that the saw head is
locked in the down position. To release the head to make it ready for operation, applying
downward pressure and pull out the release knob(29), the head will be raised gently to
upper position.
Assembly
C
D
