Customer Helpline
1300 889 028
15
Operating Instructions
8. USING THE SIGHT LIGHT
To turn on the light, press the on/off switch and make sure the forward/reverse rotation
control is on right/left position. When you release the on/off switch, the light will be off.
LED lighting increases visibility-great for dark or enclosed area.
LED is also a battery capacity indicator. It will flash when power gets low.
9. BATTERY CAPACITY INDICATOR
Your tool is equipped with battery capacity indicator. Press the on/off switch halfway or
fully, the battery capacity indicator will light up to show the amount of charge left in the
battery.
Fuel Gauge
Capacity
3 lights
>70%
2 lights
40%~70%
1 light
<40%
10. DRILLING
When drilling into a hard smooth surface, use a center punch to mark the desired hole
location. This will prevent the drill bit from slipping off center as the hole is started.
Hold the tool firmly and place the tip of the bit at the point to be drilled.
Depress the on/off switch to start the tool.
Move the drill bit into the workpiece, applying only enough pressure to keep the bit
cutting. Do not force or apply side pressure to elongate a hole.
WARNING: Tungsten carbide drill bits should always be used for concrete and
masonry. When drilling in metal, only use HSS drill bits in good condition. Always
use a magnetic bit holder (not included) when using short screwdriver bits. When
screw-driving, apply a small quantity of liquid soap or similar to the screw threads to
ease insertion.
11. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop. Relieve the load on the machine
immediately and allow cooling for approx. 30 seconds at the highest no-load speed.
12. TEMPERATURE DEPENDENT OVERLOAD PROTECTION
When using as intended for the power tool cannot be subject to overload. When the load
is too high or the allowable battery temperature of 75°C is exceeded, the electronic
control switches off the power tool until the temperature is in the optimum temperature
range again.
13. PROTECTION AGAINST DEEP DISCHARGING
The Li-ion battery is protected against deep discharging by the “Discharging Protection
System”. When the battery is empty, the machine is switched off by means of a protective
circuit: The drill will no longer rotate. Remove the battery and recharge.
