Customer Helpline
1300 889 028
13
Operating Instructions
3. REVERSIBLE (SEE FIG. F1, F2)
Forward rotating: push the forward/reverse rotation control to the left (the drill points
away from you). It is used for drilling and screw driving.
Reverse rotation: push the forward/reverse rotation control to the right (the drill points
away from you). It is used for remove screws or release a jammed drill bit.
WARNING:
Never change the direction of rotation when the chuck is rotating, wait
until it has stopped!
4. TWO-SPEED GEAR CONTROL (SEE FIG. G)
The drill has a two-speed gear control designed for drilling or driving at LO (mark is 1) or
HI (mark is 2) speeds. A slide switch is located on top of the drill to select either LO or HI
speed. When using the drill in the LO speed range, the speed will decrease and the drill
will have greater power and torque. When using the drill in the HI speed range, the speed
will increase and the drill will have less power and torque.
Gear I
Low speed range: for screwdriving or working Large diameter drill.
Gear II
High speed range: for working with small diameter drill.
WARNING: To prevent gear damage, always allow the chuck to come to a
complete stop before changing the direction of rotation or the two-speed gear
control.
When overload occurs frequently on the high speed gear, switch to the low speed gear
to avoid the motor overheating.
5. CHUCK ADJUSTMENT (SEE FIG. H)
To open the chuck jaws rotate the front section of the chuck. Insert the drill bit between
the chuck jaws and rotate the front section in the opposite direction. Ensure the drill
bit is in the center of the chuck jaws. Finally, firmly rotate the front chuck section in the
opposite directions. Your drill bit is now clamped in the chuck.
1
2
CLOSE
OPEN
1
2
D
E
F1
F2
G
H
I
J
B
C
