@
ToolkitRC
2019
28
signal value to be output.
When set to Auto 1, 2, 3, the pulse width value of
the output PWM will automatically change at 3
different speeds.
Pulse width can be set from 800 to 2200us The
cycle can be set from 2.5ms (400Hz) to 50.0ms
(20Hz).
Rotate the Jog on the output main interface to
move the cursor to the [PPM] item, press [OK] to
enter the PPM output interface as shown below.
Rotate the Knob to move the cursor to the value
that needs to be modified. Press [OK] to modify the
output pulse width value of this channel. Rotate the
Knob under the output main interface to move the
cursor to the [sBus] item, press [OK] to enter the
compatible signal output of SBus, Dbus, etc., rotate
the Knob, and switch the 16 channel value and status
bit. The display interface is as shown below (9-16
channel and status display interface diagram
omitted) Rotate the Jog to move the cursor to the
Summary of Contents for M8
Page 23: ... ToolkitRC 2019 23 ...
