@
ToolkitRC
2019
17
When selected as [StoCHG]. it will prompt the target
voltage to charge and discharge the battery. If the
discharge mode is to recover the discharge to the
power source batter. it is also necessary to set the
cutoff voltage of the battery. As shown below
The high limit voltage of recovered. The default is
0.5V higher than the input voltage. Please set
according to the maximum limit voltage of the input
power supply. To cancel the operation. move the
cursor [Cancel] or press [Exit]. Move the cursor to
[OK]. short press [OK] to start charging. and display
the charging and discharging work interface.
=================================
Tip:The discharge cutoff voltage should be
set.
1.
According to the discharge characteristics of the
battery.
2. After the recovery limit voltage is set to the
highest protection voltage of the power supply.
Summary of Contents for M6
Page 24: ... ToolkitRC 2019 24 ...
