TOOL FRANCE TFD-32TE, Operator'S Manual

Page: 21 / 39

18
UK-English
Technical Specification
Attention: Please choose proper power source, voltage and frequency that are shown in the label for your
drill press.
Drill press TFD-32TE
Voltage/ Frequency: 400V / 50Hz
Motor Power 1100W
Chuck 20mm
Spindle Travel 120mm
Spindle Taper MT4
Speed Change 12 Speeds
Speed 150 - 2450 r/min
Dist. Spindle to Column 255 mm
Table Size 455x405 mm
Base Size 580x430 mm
Column
92mm
Total Height 1720 mm
SAFETY
WARNING:
To avoid electrical hazards, fire hazards, or damage to the tool, use proper circuit protection.
Use a separate electrical circuit for your tools. To avoid shock or fire, replace power cord immediately if it is worn, cut or
damaged in any way.
GENERAL SAFETY INSTRUCTIONS
WARNING:
To avoid mistakes that could cause serious injury, do not plug the Drill Press in until you have read and
understood the following:
1. READ and become familiar with the entire instruction manual. LEARN the tool’s application, limitations and possible
hazards.
2. KEEP GUARDS IN PLACE and in working order.
3. REMOVE ADJUSTING KEYS AND WRENCHES. Form a habit of checking to see that keys and adjusting wrenches are
removed from the tool before turning ON.
4. KEEP WORK AREA CLEAN. Cluttered areas and benches invite accidents.
5. DON’T USE IN DANGEROUS ENVIRONMENT . Don’t use power tools in damp or wet locations, or expose them to rain.
Keep work area well lighted.
6. KEEP CHILDREN AWAY. All visitors should be kept at a safe distance from work area.
7.
MAKE WORKSHOP CHILDPROOF
with padlocks.
8. DON’T FORCE THE TOOL. It will do the job better and safer at the rate for which it was designed.
9. USE THE RIGHT TOOL. Do not force tool or attachment to do a job for which it was not designed.
10. USE PROPER EXTENSION CORD. Make sure your extension cord is in good condition. When using an extension
cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will result in a
drop in line voltage and in loss of power that will cause the tool to overheat.
11. WEAR PROPER APPAREL. Do not wear loose clothing, gloves, neckties, rings, bracelets, or other jewelry that may get
caught in moving parts. Non-slip footwear is recommended. Wear protective hair covering to contain long hair.