MANUAL
INTRODUCTION AND DESCRIPTION
This manual is intended to provide operation and service information necessary
for the safe and efficient use of the Tool-Co BDG250 Floor Grinder.
Operating or servicing the unit other than in accordance with the instructions
given may subject the machine to conditions beyond its capability, which may
result in machine failure or personal injury.
IMPORTANT
Read the entire operating manual carefully before attempting to use
the floor grinder. Special attention should be paid to the section titled
‘Safety Precautions’.
The floor grinder is a sturdy, reliable and easy to use machine.
The floor grinder is fitted with a 2.2kW single phase motor. This motor offers
a direct drive to the grinding plate with the incorporation of a flexible coupling
between the motor and the plate.
The shroud system is unique in design, automatically adjusting to suit segment
height and floor angle. This shroud system, when used in conjunction with an
appropriate industrial vacuum unit, eliminates dust loss during grinding. The
shroud has two removable sections to enable the operator to grind close up to
the wall etc. Please note that dust loss is possible when this section is removed.
The floor grinder comes complete with a water connection for wet grinding
should this be required. This incorporates a ball valve allowing the operator to
regulate the water supply to obtain the best grinding results.
The floor grinder has a foldable handle which enables it to be easily transported
in the trunk of most small vehicles. The rear wheels can also be extended
outward should the operator want more stability from the grinder. This requires
the use of an 8mm Allan Key. The operator can also raise or lower the height
of the handle to maximize their comfort when using the grinder, and the new
designed lifter system makes operator handy to use.
Pg.1
