5
OPERATION
Cloning Transmitter
Occasionally, it is desirable to have more than one transmitter work with a single receiver. This is accomplished by a
process called cloning. Cloning allows an additional transmitter (B) to have the same ID code as the original transmitter
(A). If this feature is desired, use the following procedure:
1. Make sure both transmitters and the receiver are OFF.
2. On Transmitter A, press and hold the UP and LIGHTS buttons for 5 seconds until the LEDs blink, then release. The
green and red LEDs will blink together at this point.
3. On Transmitter B, press and hold the UP and DOWN buttons simultaneously until both the LEDs start to blink.
4. Wait for few seconds until the green LED starts to blink on transmitter A and transmitter B.
5. Turn both of the transmitters OFF.
6. Synchronize one of the transmitters to the receiver using SYNCHRONIZING TRANSMITTER AND RECEIVER
instructions procedure.
If the cloning feature has been invoked and is no longer desired, the ID code of one of the transmitters needs to be
changed. This will unclone the transmitters. If this is desired, use the following procedure:
1. Make sure the receiver and transmitter are OFF.
2. Press and hold the UP, DOWN, and LIGHTS buttons simultaneously until both LEDs start toggling, then release.
3. Press any button again to select a new ID.
4. Uncloning process is now complete. Follow the SYNCHRONIZING TRANSMITTER AND RECEIVER procedure to
link the uncloned transmitter to a new receiver.
ONLY ONE TRANSMITTER CAN BE ON AT A TIME, THEY CANNOT BE
USED SIMULTANEOUSLY - use with CAUTION!
