4
OPERATION
Transmitter and Receiver
Operation
To turn the transmitter ON, press and hold any button for at least 2 seconds until both of the green LED flashes, then
release.
The transmitter is designed with a power saving feature which turns the transmitter OFF after 15 minutes if no buttons
are pressed irrespective of receiver status.
There are red and green LEDs both on the keypad of the transmitter and inside the receiver case. The green LED will
blink 2 times per second when the transmitter and receiver are communicating. It will blink 1 time per second if there is no
communication (i.e. - no power to the receiver).
The transmitter's red LED blinks 1 time per second if the battery is low and needs to be changed
Synchronizing Transmitter and Receiver
Each transmitter and receiver pair is synchronized together at the factory. If a new transmitter is needed, synchronizing is
required. Use the following procedure:
1. Turn both transmitter and receiver OFF.
2. With the transmitter OFF, press and hold UP and LIGHTS buttons for more than 5 seconds. LEDs start blinking.
3. Turn the receiver ON.
4. Wait for a few seconds until just the green LED begins to blink rapidly on the transmitter.
5. Synchronizing complete.
