SIMPLE TORQON (STC-type)
HOW TO OPERATE
Refer to the full instruction manul included with the tool.
For safe use
Supplied by
HOBSON ENGINEERING
10 Clay Place, Eastern Creek NSW 2766
Phone: 02 8818 0222
www.hobson.com.au
[email protected]
1.
Confirm rotating directions of socket and
reaction-bar (counteracting).
2.
Watch distance between nut and reaction-bar.
Select L-foot or I-bar (Straight-bar) and mount in
Q-connector.
3.
Mount Q-Connector on wrench drive, then mount
impact socket securely.
6.
Squeeze trigger switch. When required
torque has been reached, wrench stops and
tightening is over.
Attention
Some error is inevitable due to Torque-Coefficient
that varies by coating on the bolts and nuts when
setting required torque.
If high precision torque setting is required, the use
of dial-type torque wrench is recommended.
Tightening
* Specifications and design are subject to change without notice
Press trigger intermittently untill the reaction-bar
touches the prop (support)
4.
Adjust torque setting dial to required torque value
in Nm.
