7
NOTE: Lightly snug the knurled knobs
and make sure the wires and wire con-
nectors are completely inside the motor
cover and not pinched between the
motor cover and the motor.
7.
Position the ceiling cover over the downrod.
Be sure the cover is oriented correctly, with
the large opening at the top (Figure 6).
8.
Reinstall the hanger ball on the downrod
(Figure 6) as follows. Route the motor leads
through the hanger ball and slide the hang-
er ball over the downrod. Install the pin
through the holes at the top of the downrod
and slide the hanger ball up the downrod,
aligning the ball so the pin in captured in
the groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin
and securely tighten the setscrew in the
hanger ball. A loose setscrew could create
fan wobble.
!
WARNING
It is critical that the pin in the hanger ball
is properly installed and the setscrew
securely tightened. Failure to verify that
the pin and setscrew are properly installed
could result in the fan falling.
KNURLED
KNOB (2)
LOCKWASHER
(2)
MOTOR
COVER
1" THREADED
STUD (2)
Figure 5
SETSCREW
PIN
HANGER BALL
CEILING
COVER
DOWNROD
Figure 6
9.
Cut the white, blue, black and yellow
leads from the downrod approximately
6 to 9-inches above the hanger ball. Strip
back insulation 1/2-inch from the end of
the leads.
10.
Use three 10-32 x 3/8” Phillips pan head
screws (supplied) and three #10 flat wash-
ers to secure the fan blade to the blade
flange (Figure 7). Repeat this procedure
for the remaining four blades.
NOTE: Be sure the “THIS SIDE UP”
label is positioned as shown in Figure 7.
10-32 x 3/8" PAN
HEAD SCREWS (3)
#10 FLAT
WASHERS (3)
FAN
BLADE
THIS SIDE UP
BLADE
FLANGE
Figure 7
11.
Turn the fan motor and housing assembly
upside down in preparation for mounting
the fan blades assemblies.
BP7288-1 TB301 Paradise Key 6/17/13 10:29 PM Page 7
