6
!
WARNING
It is critical that the clevis pin in the motor
coupling is properly installed and the
setscrew securely tightened. Failure to ver-
ify that the pin and setscrew are properly
installed (as shown in Figure 4) could result
in the fan falling.
HAIRPIN
CLIP
CLEVIS
PIN
DOWNROD
SETSCREW
MOTOR
COUPLING
1.
Remove the fan motor and housing assem-
bly from the styrofoam packaging and posi-
tion it so that the top of the motor is facing
you.
2.
Remove the hanger ball from the downrod
by loosening the set-screw in the hanger
ball until the ball falls freely down the
downrod (Figure 3). Remove the pin from
the downrod, then remove the hanger ball.
Retain the pin and hanger ball for reinstal-
lation in step 8.
3.
Separate, untwist and unkink the four
motor leads. Route the motor leads through
the downrod and seat the downrod in the
motor coupling (Figure 4).
PIN
HANGER
BALL
SETSCREW
DOWNROD
Figure 3
Figure 4
How to Assemble Your
Ceiling Fan
4.
Align the clevis pin holes in the downrod
with the holes in the motor coupling. Install
the clevis pin and secure with the hairpin
clip (Figure 4). (Pin and clip are supplied in
loose parts bag.) The clevis pin must go
through the holes in the motor coupling
and the holes in the downrod. Push the
straight leg of the hairpin clip through the
hole near the end of the clevis pin until the
curved portion of the hairpin clip snaps
around the clevis pin. The hairpin clip must
be properly installed to prevent the clevis
pin from working loose. Pull on the down-
rod to make sure the clevis pin is properly
installed.
5.
Install the 5/16-18 x 1/4” setscrew
(supplied) in the motor coupling (Figure 5).
While pulling up on the downrod, tighten
the setscrew using the 5/32” hex wrench
(supplied).
NOTE: The setscrew must be properly
installed as described above, or fan wob-
ble could result.
6.
Screw two 1” threaded studs (supplied) into
the motor (Figure 5). Leave approximately
7/8” of the stud extending above the
motor. Coil the wires and wire connectors
around the motor coupling then slide the
motor cover over the downrod and rotate
the cover until the threaded studs protrude.
Install two lockwashers and knurled knobs
(supplied) to secure the cover to the motor.
All wires and wire connectors must be
enclosed under the motor cover.
BP7288-1 TB301 Paradise Key 6/17/13 10:29 PM Page 6
