Viewing and changing settings from the Parent unit
In the settings menu on the Parent unit you will see 5 icons displayed at the top of the screen.
Signal strength
When the signal strength icon shows full 4 bars, you should be able to see a clear colour image of your baby on
screen, provided the Parent unit and Baby unit are paired and within operating range.
As the distance between the camera and Parent unit increases, the signal strength will lessen and the image will be
less clear until it goes out of range. At this point the screen will revert to a still image and ‘No signal or out of range’
will be displayed on the screen at regular intervals. The visual level meter will also flash and an audio
alarm will sound.
Once the Parent unit is back within operating range the audio alarm will stop and the visual level meter
will stop flashing.
Camera number
This shows which camera is being displayed on the Parent unit.
Temperature icon
This shows the current temperature of baby’s room.
If the temperature of baby’s room is higher or lower than the limits that you preset an audio alarm will
sound and the screen will display:
HOW TO PAIR YOUR PARENT UNIT WITH YOUR CAMERA AND
MOVEMENT SENSOR MAT
Note: The parent unit and camera are already paired when purchased, however this may be required to be
re-paired if an additional monitor is purchased (cameras are not sold separately).
Only pair the camera with the movement sensor pad after pairing between the parent unit and the camera(s)
is complete, otherwise the system will not operate properly. Ensure movement sensor mat has batteries inserted.
• To pair, press and hold the pairing button on the base of the camera while switching on the camera unit (a long
press of the power button) until the transmit indicator starts flashing.
• Now press and hold the alarm button on the side of the sensitivity control box while switching on the movement
sensor pad by turning the dial towards high.
• Wait for the movement indicator to start flashing. You’ll hear two beeps from the camera, indicating pairing has
been successful.
• Switch off both the camera and movement sensor pad and switch them on again for normal operation. The
sensor pad is now ready for use.
battery icon
signal strength icon
image magnification icon
camera number
temperature icon
CAM 1
x2
23ºC
CAM 1
CAM 1
Low temperature
Alarm
100%
8ºC
CAM 1
CAM 1
High temperature
Alarm
100%
40ºC
