Tomberlin E-Merge E2, Assembly Manual

Page: 20 / 65

Page 15 200909
Mount the turn-­‐signal stalk on the steering
column approximately one inch below the
end of the steering column tube jacket
Inspect all connectors and the routing of
the wiring harness behind the instrument
panel prior to the final assembly of the
instrument panel to the unit itself
Check for fit and finish while completing the
final assembly of the instrument panel
paying close attention to the condition of
the plastic panel
NOTE:
Any deficiencies in material or workmanship
from manufacturer found now will save in time
and aggravation later
Reinstall the hardware for the instrument
panel into the floorboard
Tighten the hardware using a 5mm Hex-­‐bit
socket on an extension and a 13mm box
wrench
CAUTION:
Only tighten until a snug fit is achieved.
OVERTIGHTENING THE HARDWARE WILL
CRACK THE INSTRUMENT PANEL PLASTIC