HC-1500AT
18
AC IN
ANT 3
ANT 2
ANT 1
CONT
YAESU
KENWOOD
I N
TRX
OUT
CIV
STBY
I N
OUT
I N
OUT
DC12V
HC-1500AT
When the x-ceiver is YAESU, and linear is other than a THP amplifier, it is recommended to connect
the x-ceiver and HC-1500AT with the YAESU band data cable, then set the amplifier parameters
manually..
FUSE
FUSE
ANT
TRX
SEND
AC IN
GND
To Antenna
HC-1500AT
RCA Plug Cable
Coax Cable
DC Power Cord
Linear
Connection
ANT
BAND DATA
TX-GND
Setting Sequence
14MHz FUNC NON
C1=12 C2=19 ANT1
(1) Set the Band (minutely for 1.8 and 35MHz)
14MHz FUNC NON
C1=12 C2=19 ANT1
(2) Antenna Select
(3) Return to STBY mode
(4) Transmit the carrier and imitate the tuning.
14MHz WAIT NON
C1=12 C2=19 ANT1
14MHz STBY NON
C1=51 C2=55 ANT1
14MHz TUNE NON
C1=51 C2=55 ANT1
14MHz RADY NON
C1=53 C2=45 ANT1
(5) Tuning will be finished in a few seconds.
(6) Return to receive state once, and the linear is no longer
bypassed.
Set the band with
FUNCTION button
and SELECT dial.
Antenna should be
selected for each
band.
“WAIT” may take
approx. 3 seconds.
It may take approx.
3 seconds before
tuning is completed.
Linear is still
bypassed at this
stage.
Setting of HC-1500AT
Setting of Linear
YAESU mode
Setting of Transceiver
None
Interface = YAE
1.822 STBY FRQ
C1=12 C2=19 ANT1
Note
For 1.8 and 3.5MHz band only, please set the
correct band segment when using YAESU
radios.
Bands are divided into several segments as follows.
Manually select the nearest band segment to your
actual operating frequency.
1.8MHz
1.80Mz·1.82Mz·1.85Mz·1.87Mz·1.90Mz·1.92Mz·1.9
5Mz·1.97Mz
3.5MHz
3.5MHz·3.6MHz·3.7MHz·3.8MHz·3.84Mz·3.94Mz
To YAESU X-ceiver
11-5. Setting / YAESU with Other
Linear
