Tokyo Electronic CS3910H, Operation Manual

Page: 9 / 22

(2)Option 2 : Mounting holes (Bottom side)
Put M3 screws through screw-holes to fix the camera. Be sure to use screws which are shorter than
specified length. Longer screws may damage the inner circuit board.
(2-1)To fix your camera by using the mounting holes (a) above (= 2 places), be sure to use 3mm or
shorter screws.
(2-2)To fix your camera by using the mounting holes (b) above (= 4 places), be sure to use 5mm or
shorter screws.
(2-3)To fix your camera by using the mounting holes (c) above (= 2 places), be sure to use 3mm or
shorter screws.
7. INTERFACE
(1) DC IN/SYNC
Connector (Camera side): HR10A-10R-12PB (Manufactured by HIROSE DENKI)
Plug (Cable side): HR10A-10P-12S (Manufactured by HIROSE DENKI)
(2) DATA OUT
Connector (Camera side): DX10A-36S
Connector (Cable side): DX30A-36P, DX-36-CV 1 (Cover)
DATA0: LSB, DATA9: MSB
8
Pin number Signa1 name
1 GND
2 +12V
3 VIDEO GND,
4 VIDEO OUT
5 HD GND
6 E.HD IN
7 E. VD IN
8 GND
9 N.C.
10 WEN
11 TRIG
12 VD GND
Rear-view
Pin. Signal name Pin. Signal name Pin. Signal name Pin. Signal name
1 DATA0-H 10 DATA4-L 19 DATA9-H 28 E.HD IN
2 DATA0-L 11 DATA5-H 20 DATA9-L 29 E.VD IN
3 DATA1-H 12 DATA5-L 21 VD OUT-H 30 N.C.
4 DATA1-L 13 DATA6-H 22 VD OUT-L 31 BUSY
5 DATA2-H 14 DATA6-L 23 HD OUT-H 32 WEN
6 DATA2-L 15 DATA7-H 24 HD OUT-L 33 N.C.
7 DATA3-H 16 DATA7-L 25 CLK-H 34 N.C.
8 DATA3-L 17 DATA8-H 26 CLK-L 35 GND
9 DATA4-H 18 DATA8-L 27 TRIG IN 36 GND