10.2. Preparation
Download and run the ST Visual Programmer:
https://my.st.com/content/my_st_com/en/products/development-
tools/software-development-tools/stm32-software-development-
tools/stm32-programmers/stvp-stm32.html
unzip the archive and run the installer
Accept the program’s
default settings
the installer will create an entry labelled
ST Toolset
on your start
menu and the
ST Visual Programmer
will be available under it.
Using a #1 Philips screwdriver, remove the lid from the TBS12 case.
10.2.1. TBS12B, TBS12S, TBS12PC
The Programmer plugs in to this the 4 pin JST socket:
TBS12B: the socket is to the left of the socket used with the USB to
FTDI adaptor
TBS12S: the socket is below and to the right of the battery holder.
Connect the TBS12 to your PC using the USB to FTDI cable.
Connect the ST-Link programmer to a second USB port on the PC
the LED on the ST-Link module should glow red to indicate that the
unit is powered up.
Run the
ST Visual Programmer
program and set the configuration to
match the TBS12:
select
Configure / Configure ST Visual Programmer
Hardware
set to
ST-LINK
Port
set to
USB
