18
DIGITAL TORQUE GAUGE MODEL
ATGE-G
USB Interface
USB1.1 compliant (USB-serial conversion chip used)
Connector
USB mini B-type
Baud rate
2400/4800/9600/19200 bps (selectable)
Data length
8 bits
Serial Interface
Stop bit
1 bit
Parity
None
Flow control
Not control
7
External Output Specifications
• USB Output Method
The USB connection cable and communication driver are optionally available (Part No. 384).
· Preparation (PC)
(1) Install the communication driver to a USB-compliant PC.
(The communication driver is contained in the CD-ROM supplied with the product.)
(2) Make settings of the PC port and communication format.
(For installation procedure and communication settings, see the instruction manual in the
CD-ROM.)
· Preparation (ATGE-G)
(3) Turn on the power of ATGE-G.
(4) Select the communication baud rate (2400/4800/9600/19200 bps).
· Communication
(5) Connect the USB connection cable (option) to the PC and ATGE-G.
(6) Start up the communication software (The communication software is not included with
the product).
· Data output
(7) Data Output Method (See the “All measurement data output at a time”).
* Use the optionally available USB connection cable to connect to a PC.
* Connect the cables to PC before starting up the software. Otherwise, communication
may not be established.
* If the ATGE-G and multiple TOHNICHI USB serial output devices (CEM3, R-DT999,
ST2) are connected to a PC at the same time, communication may not be established.
* Do not connect ATGE-G to PC with USB cable when no battery is installed, or when the
battery is running out (Battery alarm).
• Output Format
plus (+): nothing is displayed (blank).
minus (-): "-" is displayed.
Header
Counter (3fig)
Torque (decimal point) Delimiter
ATGE-G型 取扱説明書̲CS5.indd 19
ATGE-G型 取扱説明書̲CS5.indd 19
2016/06/06 16:37:30
2016/06/06 16:37:30
