TOHATSU MFS 8A3, Owner'S Manual

Page: 25 / 72

Air Vent Screw
Before starting engine for the first time
after reassembling engine or off-season
storage, disconnect stop switch lock
and pull the starter handle completely
out approximately 10 times in order to
prime the oil pump.
① Loosen the air vent screw on the
tank cap.
② Attach the fuel connector to the
engine connector.
The arrow mark on the primer bulb
should be facing the engine.
③
Feed fuel to the carburetor by
squeezing the primer bulb until it
is firm.
④
Be sure to install the stop switch
lock to the stop switch.
25
1
2
3
4
5
6
7
8
9
10
11
12
13
PRE-OPERATING PREPARATIONS
Before starting
1. Starting
Note
The engine will not start unless
the switch lock has been properly
connected into the emergency stop
switch.
ENGINE OPERATION
Fuel tank side
Engine side
!
�������
In case engine starts in gear, do not
start cruising. Stop engine immediately
and consult an authorized dealer.
!
�������
Do not operate the engine with gear
case out of water.
Severe personal injury, or engine
damage will result.
Fuel
Connector
Engine side
Stop Switch Lock
Stop Switch Lock